TruDesigns Y Joiner 3 x 1in (25mm) Barb – Marine Polymer Plumbing Fitting

You're staring at a half-finished bilge line and the one fitting you need isn't on the shelf at the chandlery down the road. This TruDesigns Y joiner splits a single 25mm (1in) barb feed into three outlets, so you can route water intake or discharge where your layout actually demands it. Polymer body, no rust, no galling. Need a threaded connection instead? Trim the barbed tail and thread it in. Cut, fit, done — before the next tide

• Y-branch configuration with three 1in (25mm) barbed outlets
• Polymer body resists corrosion in saltwater plumbing runs
• Suitable for drawing water into or discharging out of a boat
• Commonly used for bilge pump discharge routing
• Barbed tails can be trimmed to accept threaded connections