TRUDESIGNS Polymer 90° Elbow – 1½" BSP Thread to 38mm Barb Connector

Your bilge pump discharge line's leaking at the elbow, or you're trying to route an intake hose around a tight corner and nothing seats properly. This TRUDESIGNS polymer elbow sorts it. One side is a 1½" BSP thread – bolt it straight onto your fitting. The other is a 38mm barb – slide your hose on and clamp. If the barb's longer than you need, cut it down. No welding, no special tools. Just a clean 90° turn where your layout demands one

• 90° polymer elbow: 1½" BSP thread to 38mm barb
• Commonly used for bilge pump discharge or water intake on boats
• Barb connector trims to suit your hose length
• Polymer body – lightweight, no metal to corrode