Jaycar 10K Ohm Logarithmic (A) Double Gang 24mm Potentiometer – PCB & Panel Mount

Linear taper sounds fine on a spec sheet until you turn the knob and the whole lower half of the range does nothing. If you're building an audio or volume control circuit, you want logarithmic. This 10K log (A) double gang gives you that natural, ear-matched response across the full rotation. Same physical build as the linear versions — 24mm body, 6.35mm shaft with a flat for your knob, 38mm long. Solder it in and it holds; six contact points on phenolic, centre pin offset from the outer terminals. No extra brackets. Panel-mount with the 3/8" 32 T.H.D. bush and it's locked in place. Pins take screened cable for hard-wired jobs. 0.5W max. Standardised design with a published engineering drawing so your PCB layout matches on the first pass

• 10K Ohm logarithmic (A) taper, double gang, 24mm diameter
• Self-holding PCB mount — six contact points, no extra mechanical fixing needed
• 6.35mm shaft with 25% flat for grub-screw or interference-fit knob, 38mm long
• 3/8" 32 T.H.D. bush for secure panel mounting
• Pins sized to terminate screened cable for hard-wired builds
• 0.5W max power rating