100K Ohm Linear (B) Single Gang 24mm Potentiometer – Jaycar RP3518

That 100K pot you grabbed off a marketplace? Probably a 95K in disguise. This one's stamped, standardised, and built to spec. Jaycar's 24mm single-gang linear (B) pot gives you a 6.35mm shaft with a machined flat for knob mounting — no wobble, no slip. The 3/8 32 T.H.D. bush locks it to your panel properly. Solder the phenolic pins into your PCB and it holds rigid without extra support. Pins are thick enough for screened cable if you're wiring it up by hand. 0.5W max. One design, every unit, so your PCB artwork stays true

• 100K ohm linear (B) taper, single gang
• 24mm diameter body, 0.5W max power rating
• 6.35mm (1/4 in) shaft, 38mm long, machined flat for grub screw or interference-fit knob
• 3/8 32 T.H.D. panel bush for secure fixing
• PCB mount with phenolic pin base; centre pin offset from outer terminals
• Pins sized for screened cable or hard-wire termination